GW Instek PEL-2000A Series - Select CC Dynamic Mode

OPERATION
129
Panel Operation
1. Press the F2 (Range) key repeatedly
until High or Low range is selected.
Range
High
Range
Low
F2
The range will be reflected in both the
bottom menu system and the Current
Operation Channel Status panel.
CCDH
main
80V
CH1P
CC Dynamic Low
CC Dynamic High
CC Static Low
CC Static High
CCDL
CCDH
CCL
CCH
Note
Changing the range will only affect the current
(active) channel. Other channels will not be affected
by any changes.
Note, not all load modules support dual ranges. If
only one range is supported, it is usually high range.
Select CC Dynamic Mode
Background
Constant current mode can be set to dynamic or
static mode. Dynamic mode is used to
automatically set varying load rates.
Ensure the menu is in CC Mode. See page 128.
ConfigureConfigure
Mode
CC
Dynamic
Range
High
Panel Operation
1. Press the F3 key until Dynamic
Range mode is selected.
Dynamic
Static
F3