GW Instek PEL-2000A Series - Sequences

PEL-2000A Series User Manual
110
Sequences
Sequences are used to accurately simulate loads. As each Sequence
is independent, Sequences are ideally suited to test multiple output
power sources.
DUT
Step
Description
Details
1. Setup
Choose the appropriate load
module(s).
Page 38
2. Connection
Connect the terminals to the DUT.
Page 45
3. Channel
selection
Select a load channel with the
mainframe.
Page 126
4. Channel
setup
Create a sequence.
Page 163
5. Sequence
loop
Create a sequence loop if
necessary.
Page 165
6. Multiple
channels
If multiple channels need to be
configured, follow steps 1-5 for
any remaining channels.
7. Channel
Duration
menu
Edit the sequence channel
duration information. Ensure that
the channels containing Sequences
are not set to OFF.
Page 167
8. Trigger
Settings
Set Trigger Out and In channels, if
appropriate.
9. Run
Run the Sequence(s)
Page 170