GW Instek PEL-2000A Series - Saving;Recalling Sequences to USB

PEL-2000A Series User Manual
268
If you try to recall data that originated from a different
load module than the active channel, an error message
will appear. The filename must reflect the active
channel’s load module type.
Machine Type Error
Saving/Recalling Sequences to USB
Background
There are two options to save or recall Sequences to
a USB flash drive. Sequences can either be saved
from all channels or from the current channel only.
Save All: Every channels’ sequences will be saved
into a directory (ALL00XX) as separate files for
each channel (20XXX_C1.A~ 20XXX_C8.A).
Save Current: The current channel’s sequence will
be saved into the root directory (20XXX_XX.A).
Press F5 (File Utility) to select the directory to save.
Recall: Sequences can only be recalled for the
current channel. It is not possible to recall all
channels’ Sequences at once.
The file extension *.A is used for Sequences only.
For more information about the file structures see
page 94.
Parameters
Save Channel Data:
All
Directory: ALL0000 ~ ALL0099
File: 20XXX_CX.A
Save Channel Data:
Current
File: 20XXX_XX.A
Recall Channel
Data: Current
File: 20XXX_XX.A