GW Instek PEL-2000A Series - Adjusting the Knob Control Type

OPERATION
215
6. Repeat the above steps for any connected
slave mainframe units.
Frame control is now ready for both master and
slave mainframes.
Adjusting the Knob Control Type
Background
The mainframe control knob can be set to
“Update” or “Old” mode.
When setting to Update mode, rotating the
mainframe knob will change the setting value of
load module at the same time.
When setting to Old mode, rotating the
mainframe knob won’t change the setting value of
load module unless pressing the knob or Enter
key.
Parameter
Knob Type
Updated/Old
Panel operation
1. Press the Shift Key then the Help
key to access the Utility menu.
UTILITY
HELP
SHIFT
2. Press F5 (Other Menu).
F5
ConfigureOther
Other Setting
Brightness
Frame CONT
Alarm Tone(M)
Alarm Tone(S)
Knob Type
64
OFF
OFF
OFF
Updated
Load Interface
LOAD
USB
Time Set
System
Info
06/15/18
16 : 50