GETTING STARTED
43
Power Up & Self Test
1. Connect the power cord
to the power socket.
2. Turn the external power
switch on.
3. Hold the power button
on the front panel to
turn on the power.
The power button turns
green from red (standby).
Ensure that the power outlet has a ground socket. The
power outlet will have a ground connection if it is a 3
socket type.
Upon turning on, the Mainframe will perform a
self-test. The self-test checks the System, followed
by any attached channels.
When the firmware version of the mainframe and the
slave are not identical, a message “The firmware will
be updated, please access to website
www.gwinstek.com to confirm the firmware version.”
will appear on the mainframe.
To Next Page
Loading...
