GW Instek PEL-2000A Series - Configuring Response Time

PEL-2000A Series User Manual
200
3. Press the Selector knob to edit
the selected setting, turn to
change the setting.
OR
Use the number pad to enter a
number.
CAL.
987
3
CLEAR
21
0
4 5 6
P0 LOCK
P3P1 P2
P6P4 P5
P9P7 P8
CCP Step
0.002 A
4. Press the Selector knob or Enter
to confirm selection.
OR
ENTER
5. Repeat steps 2-4 to edit the step resolution of:
CCL Step
CRH Step
CRL Step
CVH Step
CVL Step
CPH Step
CPL Step
Note
The Step resolution settings only apply to the active
channel, other channels will not be affected.
Configuring Response Time
Background
The Response time setting is used to limit current
draw when input voltage less than 1V. The
Response setting sets the bandwidth of the load to
Fast (100kHz) or as Normal (1kHz).
Parameters
Response
Normal, Fast
Panel operation
Ensure the menu is the configuration menu. See
page 180.
Configure
Previous
Menu
Protection
Go-NoGoOther Group
1. Press the F2 (Other) key to enter
the other menu.
F2