Like Programs, Sequences must be turned “ON”
before they can be run.
When running a Sequence, the front panel
function keys, number pad, operation keys and
selector knob are disabled for the specific
channel(s). The load module panel is also disabled
(bar the display key) for the specific channel.
Channels that do not have a Sequence can still be
edited by changing channels via the CHAN key or
by using the local load module.
Ensure the Channel Duration Time
Settings have also been configured
and that no Sequence (CH01~08) that
you wish to run are set to OFF.
1. Press FUNC, then Sequence (F2)
to enter the Channel Duration
Time Setting menu.
To Next Page
Loading...
