OPERATION
169
2. Use the Selector knob to
highlight a channel.
3. Press the Selector knob to edit
the channel, and then turn to
choose which channel’s Duration
Time Setting to import.
4. Press the Selector knob or Enter
to confirm selection.
5. Press Define TRIG OUT (F2) if
you want the currently selected
channel to output the Trigger
sequence signal.
One channel must be set as the TRIG OUT
channel.
6. Press TRIG In Channel (F4) to
allow the current sequence to be
triggered with the Input trigger.
7. To turn the Input trigger source
on, press Trig In (F5).
8. Repeat the above steps for any other
remaining channels.
9. Press Save (F3) to save the
settings.
To Next Page
Loading...
