GW Instek PEL-2000A Series - Page 168

PEL-2000A Series User Manual
168
At least one channel must output a Trigger
Sequence Signal via PIN4 of the first frame link
connector (master) if a sequence is run. For more
details see page 77.
The Trigger In signal is used to start any sequence
that has TRIG set to IN. The trigger input signal is
input via PIN4 of the first frame link connector
(slave). For more details, see page 77.
Any channels with channel control (CH CONT)
set to external will be shown on the right side as
EXT. See page 192 for details on setting channel
control.
Parameter
CH 01~08 Setting
OFF ~ maximum channels
CH 01~08 TRIG
IN , OUT , IN/OUT, OFF
Ensure at least one sequence has been created and
saved. Page 163
Panel operation
1. Press FUNC, then Sequence (F2)
to enter the Channel Duration
Time menu.
FUNC
F2
Configure
02
03
04
Channel Duration Time Setting
OFF
OFF
OFF
OFF
CH
01
Setting
Seq.
Off
Save
IN
TRIG
Define
TRIG OUT
TRIG In
Channel
TRIG In
Off
OFF
IN/OUT
OFF
LOAD
USB
EXT
06/15/18
16 : 50
Note
CH3 is set to TRIG OUT, whilst CH1 & CH3 are set to
TRIG IN. CH2 has no trigger settings and has CH
CONT set to external.