GW Instek PEL-2000A Series - Configuring the GPIB Address

OPERATION
235
O
USB
Interface
ConfigureOtherInterfaceLoad
LOAD
USB
Time Set
System
Info
06/15/18
16 : 50
7. Connect the USB cable to the
USB-B slave port on the rear.
8. When the PC asks for the USB driver, select
PEL-2000A.inf (downloadable from the GW
Instek website, www.gwinstek.com, PEL-2000A
product corner).
Note
For USB CDC function check, please refer to the
section “RS232 and USB CDC function check” on page
238.
Configuring the GPIB Address
Background
When using GPIB, an address must be specified.
Parameters
Address
01~30
Panel operation
1. Press the Shift Key then the Help
key to access the Utility menu.
UTILITY
HELP
SHIFT
2. Press F3 (Interface Menu).
F3