GW Instek PEL-2000A Series - Adjusting the System Mode

OPERATION
223
Adjusting the System Mode
Background
1: When any command is received, the Master
panel will automatically enter the Remote fast
mode.
0: The Master panel won’t automatically enter the
Remote fast mode.
Note
For details about remote mode fast/normal, please
refer to command :UTILity:REMote:MODE in the
programming manual.
Parameters
System Mode
0/1
Panel operation
1. Press the Shift Key then the Help
key to access the Utility menu.
UTILITY
HELP
SHIFT
2. Press F5 (Other Menu).
F5
ConfigureOther
Other Setting
High Resolution
System Mode
Von Latch Clear
Measure Period
Jog Shuttle Control
ON
0
Auto
200ms
OFF
Load Interface
LOAD
USB
Time Set
System
Info
06/15/18
16 : 50
3. Use the Selector knob to
highlight System Mode.