GW Instek PEL-2000A Series - GPIB Installation

PEL-2000A Series User Manual
40
GPIB Installation
WARNING
To avoid static electricity, please use appropriate anti-
static work practices.
GPIB Card
installation
The PEL-2004A/PEL-2002A has GPIB as an option
( ddpart no. PEL-001).
Steps
1. Ensure the mainframe is disconnected from
mains power.
2. Remove the screws from the GPIB cover plate
and remove the cover plate from the rear
panel.
3. Slide the GPIB card into the slot and push
gently until the back plate is flush with the
rear panel.
1
2
4. Use the screws that were removed from step 1
to secure the GPIB card.