TUTORIALS
111
Frame Link
Frame link connections are used connect up to four slave main
frames to a master main frame. When using frame link connections
it is possible to perform a number of operations in parallel under
the control of the master unit.
Connect the mainframes together.
Configure the Frame CONT to ON
for all mainframes.
At first both the master and slaves are independent.
FRM (Frame Master) can be seen on the top panel
of the each mainframe. When a mainframe is
connected as a slave unit, the FRM icon will change
to FRS (Frame Slave). The front panel keys are
disabled on slave units when in slave mode (FRS).
See the tutorial sections for
programming or channel
configuration.
To Next Page
Loading...
