GW Instek PEL-2000A Series - Page 112

PEL-2000A Series User Manual
112
4. Run
Run the loads. To run the loads,
press the LOAD key on the master
mainframe. To stop, press again.
When the LOAD key is pressed all
loads will be active.
ON /
OFF
LOAD
Options
5. Load Preset
memory
Load preset memory on the
mainframe and all frame-linked
slaves.
Page 275
6. Load Setup
Memory
Load setup memory on the
mainframe and all frame-linked
slaves
Page 274
7. Set slave to
indepen-
dent
Press shift + CHAN on the slave
unit to enable local control on a
slave unit.
FRS FRM
LOCAL
CHAN
SHIFT
Note
When a load is run or memory is recalled from the
master mainframe, the slave unit will return to
mainframe control.
Ensure the same firmware is installed on both master
and slave mainframes.