PEL-2000A Series User Manual
150
Creating a Program Sequence
The PEL-2000A series has a total of 12 different
programs and 10 sequences to each program. That
totals to 120 different configurations.
Each Sequence in each program uses the settings
saved from Memory Data (Memory MXXX).
Memory Data contains settings such as the mode
and range for each channel. Different Sequences
can use the same Memory Data repeatedly. Each
Sequence loads all channels at the same time,
unless programmed otherwise.
CH2 M001
CH3 M001
CH1 M001 Run
On-Time
Off-Time
Short-Time
Short CH1
Short CH8
~
P/F-Time
CH5 M001
CH6 M001
CH4 M001
CH8 M001
CH7 M001
Sequence1
Sequences are run sequentially to create a
Program. There are 10 Sequences in each Program.
1 2 3 4 5Sequence
Program 1
(P01)
6 7 8 9 10
If less than 10 Sequences are desired for a
Program, any additional Sequences can be
skipped (not run).
Sequence 2 & 3 are skipped.
1 2 3 4 5Sequence
Program 1
(P01)
6 7 8 9 10
To Next Page
Loading...
