GW Instek PEL-2000A Series - Select CP Range

PEL-2000A Series User Manual
148
Note
The last Value (A Value or B Value) that is set
becomes the active setting. To swap between A Value
and B Value, use the A/B keys on the local load
module.
A/B Value can be set for both High and Low Range.
When setting the current limit, please ensure that the
current limit is within the test device’s limits.
*Press Shift to toggle between coarse and fine
adjustment when editing the A Value and B Value
parameters. See page 197 for details.
Select CP Range
Background
Constant Power mode can run in high and low
range. The maximum range is dependent on the
load module. Some models are only high range.
Ensure the menu is in CP Mode. See page 141.
ConfigureConfigure
Mode
CP
Range
Low
Panel Operation
1. Press the F2 (Range) key
repeatedly until High or Low
range is selected.
F2
Range
High
Range
Low
The range will be reflected in both the
bottom menu system and the Current
Operation Channel Status panel.
CPL
CH1
main
80V
CP High Range
CV Low Range
CPH
CPL