GW Instek PEL-2000A Series - Page 105

TUTORIALS
105
8. Static Values
(CC, CR, CV,
CP)
Set the A(B) Value, slew rate (CC,
CR) and current limit (CV, CP)
CC Page 132
CR Page 139
CV Page 142
CP Page 146
9. Go/NoGo
Set the Go/NoGo configurations,
if applicable.
Page 200
10. Protection
Modes
Configure the protection modes.
Page 181
11. Run
Activate the load by pressing the
load key.
ON /
OFF
LOAD
Optional
12. Configuration
There are number of
configurations that apply to all
channels. For details see the
Configuration Tutorial.
Page 115