GW Instek PEL-2000A Series - Page 171

OPERATION
171
2. Press Seq. (F1) to turn on the
Sequences.
F1
3. SEQ will be displayed on the Mainframe
Status panel.
SEQ
USB
4. Press the LOAD key to run all
the Sequences. If a channel has
TRIG set to IN, that channel will
now wait for a trigger before
running.
ON /
OFF
LOAD
5. Run SEQ Mode will be displayed on the
bottom of the display for the specific channels.
On the Mainframe Status panel, SEQ will turn
orange.
02
03
04
Channel Duration Time Setting
01
02
OFF
OFF
CH
01
Setting
OUT
TRIG
OFF
OUT
OFF
SEQ
USB
Run SEQ Mode
06/15/18
16 : 50
Stop the load
6. Press the LOAD key again or
wait for the Sequence (if not
infinitely looped) to end/stop
the load.
ON /
OFF
LOAD
Turn off SEQ
7. Press Seq. (F1) to turn OFF the
Sequence(s) when the load is not
running.
F1