GW Instek PEL-2000A Series - Page 158

PEL-2000A Series User Manual
158
3. Press the FUNC key, Program
(F1) and Active Channel (F2).
FUNC
F1
F2
Channel 1 (CH01) will be highlighted. Note CH1 has
CH CONT set to External
Configure
Previous
Menu
Save
Recall
Default
02
03
04
Active Channel for Program Mode
OFF
OFF
OFF
OFF
CH
01
Active
Prog
Off
EXT
LOAD
USB
06/15/18
16 : 50
4. Edit the channel using the
Selector knob.
CH 01~08: ON (activate channel) – OFF (not
activated)
5. Press Enter or push the selector
knob to confirm the selection.
OR
ENTER
6. If needed, repeat steps 4-5 for the remainder
of the channels.
Note
If all channels are Active OFF, a program cannot be
run as there will be no channels active.
Save Program
7. To save press F3.
F3
Recall Default
8. To recall default settings press
F4
F4
Note
If the Default is recalled, all channels will revert to
Active OFF.