GW Instek PEL-2000A Series - Page 206

PEL-2000A Series User Manual
206
CCDH
Configure
Previous
Menu
Protection
Go-NoGo
CH1
Other
Group Mode
Display Mode
Total Unit OFF
Para
V,I
conf
Group
LOAD
USB
80V
06/15/18
16 : 50
4. Use the Selector knob to change
Total Unit from the OFF setting
to the number of parallel units.
U
s
Total Unit 2
5. Press the selector knob or Enter
to confirm.
OR
ENTER
Parallel Mode
6. To change the type of mode, use
the Selector knob to edit Group
Mode.
7. Choose Para to operate the units
as a single large load module, or
choose Sync to synchronize the
load settings across each parallel
unit.
U
s
Group Mode Para
Display Mode
8. Use the selector knob to change
the display settings on the local
load modules.
9. Choose from V, I / V, W / I,W
or S.