GW Instek PEL-2000A Series - Page 30

PEL-2000A Series User Manual
30
RS232 port/
GPIB port
RS232C
The RS232 and GPIB port is used for
remote control connections.
RS-232C: DB-9 pin male
GPIB: 24-pin female
See pages 281, 282 for remote control
details.
USB-A(host)/
USB-B (device)
port
The USB-B (device) port, like the
RS232/GPIB port is used for remote
control. The USB-A(host) port is
reserved for power delivery 5V only. If
USB-A (host) is used as a USB flash
memory slot, the interface must not set
to USB.
See page 94 for interface details.
Frame Control
Port
2
1
FRAME CONT
The Frame Control port is used
for Frame Link connections.
Mainframes are daisy-chained
together. There are two Frame
control ports.
1: Slave
2: Master
Connection type: MIL 20-pin
connector.
For details about frame link
connections see page 55, 286.
Power Switch
External Power Switch