GW Instek PEL-2000A Series - Page 319

INDEX
319
INDEX
Alarm configuration ..... 217, 228
All Chan save/recall
description ........................... 98
Baud rate configuration........ 232
Brightness & contrast .... 212, 223
Calibration ............................. 296
Calibration key ........................ 21
CC vrange mode description . 86
CC+CV mode.......................... 68
Channel configuration
CC voltage range ................. 185
Go/NoGo mode .................... 201
Go/NoGo On/Off ............... 203
Independent setting ............ 193
Load delay time ................... 195
Parallel mode ....................... 204
Protection All Clear ............. 184
Response time ...................... 200
SPEC test ON/OFF ............. 203
Step resolution ..................... 197
Channel configuration
Configuration menu ............ 180
OCP/OCV/OPP .................. 181
Channel configuration
Von voltage configuration . 187
Channel configuration
Short ...................................... 189
Channel configuration
channel control .................... 192
Channel control configuration192, 284
Channel control connection ... 57
Channel control description .. 90
Channel control mode
description ........................... 87
Channel duration time
settings mode description .. 80
Cleaning the instrument........... 8
Clear key .................................. 22
Configuration mode
description ........................... 84
Connection
Channel control...................... 57
Frame link ............................... 55
Go/NoGo control .................. 60
Remote sense .......................... 50
Wire gauge ............................. 46
Wire Inductance ..................... 46
Connection procedure ............ 48
Constant power mode
description ........................... 70
Constant Resistance mode
description ........................... 65
Constant voltage + constant
current mode description ... 68
Constant voltage mode
description ........................... 67
Declaration of conformity .... 318
Default Settings ..................... 302
Delay time mode description 88
Dimensions ............................ 315
Display key .............................. 32
Display settings ............. 212, 223
Disposal instructions ................ 9
Dynamic constant current
mode description ................ 63
Dynamic loads Constant
Resistance mode description66
EN61010