GW Instek PEL-2000A Series - Page 321

INDEX
321
R/L keys ............................... 120
Shorting ................................ 123
Static ...................................... 121
Lock key ................................... 22
Mainframe configuration
alarm sound ................. 217, 228
Brightness & contrast .. 212, 223
Configuration menu ............ 208
Frame control 213, 223, 226, 229
Go/NoGo Tone ................... 218
Knob type ..................... 215, 227
Lanuage ................................ 220
Load menu ........................... 210
Slave knob .................... 219, 229
Speaker ......................... 211, 221
System Info ........................... 208
Utility menu ......................... 208
Mainframe operation
CC Dynamic mode .............. 129
CC Mode ................................ 128
CC Range .............................. 128
CC Static mode .................... 132
CC Static Values..................... 132
Channel duration time
settings ............................. 167
Channel Selection ........ 126, 127
CP Current limit ................. 146
CP mode ................................ 145
CP Power values .................. 146
CP range ....................... 144, 148
CR Range ............................. 135
CR Static Parameters .......... 139
CR Dynamic mode .............. 136
CR mode ............................... 134
CR Static mode .................... 139
CV Current limit ................. 142
CV mode ................................ 141
CV response speed .............. 144
CV Voltage values ............... 142
Edit Sequence ....................... 163
OCP test automation ........... 173
Program chain...................... 155
Program Execution .............. 157
Program Sequences ............. 150
Programming ....................... 150
Recall default chain ............. 157
Recall default sequence ....... 154
Run Sequence ....................... 170
Save chain ............................. 157
Save Program chain ............. 157
Save sequence ...................... 154
Sequence loop ...................... 165
Trig out ................................. 167
Measurement types ........... 17, 19
Memory data description ....... 95
Number pad ............................. 21
OCP test automation............. 173
OCP Test Automation
description ........................... 82
Operating configurations
mode description ................ 86
Operating Description ............ 61
Operating Modes
Channel duration time
settings ................................ 80
Configuration ......................... 84
Configuration - Over current
protection ........................... 85
Configuration - Over power
protection ........................... 85
Configuration - Over voltage
protection ........................... 85
Constant current – Go/NoGo64
Constant current – Slew rate 64
Constant current -Dynamic .. 63
Constant current -static ......... 63
Constant Power...................... 70
Constant Resistance ............... 65
Constant Resistance –
Dynamic loading ............... 66
Constant Resistance – Slew
rate ...................................... 67
Constant Resistance
Go/NoGo ........................... 67
Constant Voltage ................... 67
Constant Voltage – Response
speed ................................... 69