PEL-2000A Series User Manual
56
The first mainframe that is connected is the master
frame; any additional frames are slave units. The
ribbon cable connects to the master from
connector 2, and the slave from connector 1. Each
successive slave unit is connected in a cascading
manner the same way.
Ensure the Mainframes are turned off before
connecting the ribbon cables. Push the cable into
the frame link connector. Ensure the arrows line
up. The latches will close when the connection is
complete. To remove, pull the latches out and
connector will come out.
Ensure all the mainframes are off and disconnected
from mains power before connecting.
To Next Page
Loading...
