Static mode tests the stability of the voltage output
from a power source. Single channel load modules
can have two 2 current levels A (A Value) & B (B
Value). A & B have the same range. Pressing the
A/B key on the module load will cycle through
the A and B states. Alternatively, the mainframe
can select A or B Value.
Dual channel load modules only have one current
level (A Value) per channel in static mode.
Dynamic load functions allow you to set load
levels (Level1, Level2), load time (Timer1, Timer2),
and the slew rate (rising, falling). Depending on
the settings, the load will switch automatically
between levels 1 and 2.
Dynamic loading can be used for charge discharge
cycle testing etc.
To Next Page
Loading...
