GW Instek PEL-2000A Series - Page 7

SAFETY INSTRUCTIONS
7
Safety Guidelines
General
Guideline
CAUTION
 Do not place any heavy object on the PEL-2000A
series.
 Avoid severe impact or rough handling that
leads to damaging the PEL-2000A series.
 Do not discharge static electricity to the PEL-
2000A series.
 Do not block or obstruct the cooling fan vent
openings.
 Do not perform measurement at circuits directly
connected to Mains (Note below).
 Do not disassemble the PEL-2000A series unless
you are qualified as service personnel.
 The equipment is not for measurements
performed for CAT II, III and IV.
(Measurement categories) EN 61010-1:2010 specifies the
measurement categories and their requirements as follows. The
PEL-2000A series falls under category I.
 Measurement category IV is for measurement performed at the
source of low-voltage installation.
 Measurement category III is for measurement performed in the
building installation.
 Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
 Measurement category I is for measurements performed on
circuits not directly connected to Mains.
Power Supply
WARNING
 AC Input voltage range: 100-120Vac/ 200-
240Vac (90-132Vac/ 180-250Vac)
Frequency: 47~63Hz
Power rating: PEL-2004A: 250VA Max
PEL-2002A: 150VA Max
 Connect the protective grounding conductor of
the AC power cord to an earth ground, to avoid
electrical shock.