GW Instek PEL-2000A Series - Page 71

OPERATING DESCRIPTION
71
CP + CC
When using CP mode, a current limit can be set
for CP + CC mode.
When the constant power current is less than
current limit, the channel will operate in CP mode.
When the constant power current exceeds the
current limit, the channel will operate in CC mode.
High/Low Range
There are two ranges: High and Low. The Low
range is used for low power ranges, whilst the
High range uses high power ranges.
CP Mode
High range
Low range
V
A
Go/NoGo
Go/NoGo testing can set High and Low Current
limits as a Value (in Amperes) or as a percentage.
A delay time of up to 1 second can also be set.
CP Mode
Load Input
Voltage
Load Current
NoGoGo
No
Go