GW Instek PEL-2000A Series - Page 96

PEL-2000A Series User Manual
96
SEQ Data
SEQ data contains Sequence data. SEQ data can
only be saved to and from USB. SEQ refers to
Sequence data, not Program sequences.
Internal Format
External Format
N/A (Internal buffer)
20X0X_XX.A
SEQ Contents
SEQ data contains the following data;
Seq.Edit
 No. (Points)
 Slew rate
 Duration time
 Value
 Slew rate
Loop
 Repeat
 On End Load
 Start of Loop
 CC Vrange
Setup Data
Setup data can be saved to 4 internal memory
slots. Setup data contains Memory data, Program
Sequence, Chain data, configuration settings and
operation settings for every channel. Setup data
can be saved to Internal memory or to USB.
Internal Format
External Format
Setup Memory 1~4
200X0_XX.S
Setup Contents
Setup data contains the following data;
Program
 PROG
 Memory
 On-Time
 P/F-Time
 Short Channel
 SEQ (program
sequence no.)
 Run
 Off-Time
 Short-Time
Chain
 Start
 Program
Sequence
(P01~P12)
Run
 Active Channel
(CH01~08)