Hamilton G5 - Connecting the CO; Inserting the Sample Cell into the Receptacle

624074/07 3-11
To set up the device for CO
2
sidestream monitoring:
1. Plug the LoFlo CO
2
Module cable into the CO
2
module con-
nector (yellow), observing the orientation of the indexing
guides on the connector body. The cable must snap into
place.
Figure 3-6. Connecting the CO
2
sensor cable
2. The sample cell of the sampling kit must be inserted into
the sample cell receptacle of the LoFlo™ CO
2
Module as
shown in the figure below. A “click” sound will be heard
when the sample cell is properly inserted.
Figure 3-7. Inserting the sample cell into the receptacle