Hamilton G5 - Vent Status Window; Vent Status: Configuring the Vent Status; Intelligent Panel; Vent Status: Configuring the Vent Status Intelligent Panel

624074/07 J-11
J.7 Vent Status: Configuring the Vent Status
intelligent panel
When the Vent Status window is open, (Figure J-9) you
can configure the Vent Status intelligent panel (Figure J-10)
according to your institution’s protocol for weaning.
Oxygen, PEEP, MinVol, and Pinsp are always shown in the
Vent Status panel, but you can configure the remaining two
parameters from these choices: RSB or P0.1, and VariIndex
1
or
%fSpont.
When Quick Wean is enabled, the Vent Status window moni-
tors weaning settings. For details, see the Quick Wean chapter
in the INTELLiVENT
®
-ASV manual.
Figure J-9. Vent status window
1. The variability index (VariIndex) parameter is not available in all markets.