Hamilton G5 - Defaults Window; Defaults: Configuring Default Settings

J-18 624074/07
J Configuration
2. Select the appropriate options. For details, see Section
F.8.1.1.
3. Confirm the selection and touch
Close .
4. If you are done configuring the ventilator, touch
Close/
Save
to save your selections.
Configuring the Masimo pulse oximeter settings continues in
the
System -> Sensors On/Off window and in the
System -> SpO2 window. For details, see Section F.8.1.3.
J.12 Defaults: configuring default settings
The Defaults window open you can configure default
settings for mode and controls. All operator set defaults can be
configured individually for each patient group.
Figure J-17. Defaults window
To configure default settings:
1. Starting from the
Standby screen, select the patient group
for which you want to configure default settings.
2. Start normal ventilation using a lung model.