624074/07 5-7
5.4 Modes window: Setting the ventilation mode
NOTE:
• For details on modes, see the following chapters or
materials:
Adaptive Support Ventilation (ASV
®
)
INTELLiVENT
®
-ASV
Noninvasive ventilation
Modes of ventilation
• Table 5-1 describes which modes apply to which
patient profiles.
See the top right-hand corner of the screen for the active ven-
tilation mode. To change the mode use these steps:
1. Open the
Modes
window.
2. Select a mode. The mode framed in the color yellow within
the mode group is the apnea backup mode for that partic-
ular group of modes.
A.
Confirm
the mode. The
Controls
window opens
automatically. Review and confirm the control settings
(see Section 5.5.2). If the control settings are not con-
firmed after 3 minutes, the window automatically
closes. If this happens, the new mode selection will not
be valid, and the previous settings remain in effect.
To Next Page
Loading...