624074/07 F-33
F.8.1.1 Configuring Masimo data acquisition options
NOTE:
If you are upgrading the system by adding another
parameter measurement, select
Upgrade
. See the
HAMILTON-G5 Service Manual for details on the
upgrade process.
Configuration is performed in Standby.
To configure data acquisition options (see Figure F-7):
1. In the
Configuration
-
>
SpO2
window, select
Masimo
.
Masimo-specific settings are displayed.
Figure F-7. Masimo data acquisition parameters
2. Select the appropriate settings. For definitions, see Table
F-10.
To Next Page
Loading...