Hamilton G5 - Configuring the Oximeters; Configuring the Masimo Options; Options; Masimo Option Settings

F-32 624074/07
F Pulse oximetry
F.8 Configuring the oximeters
Configuration differs between the supported pulse oximeters.
F.8.1 Configuring the Masimo options
Setting up the pulse oximeter comprises the following steps,
each of which is described in the following sections.
Configure:
Table F-9. Masimo option settings
Parameter Parameters to configure See Section ...
Data acquisition
options
• Sensor type (Nihon-Kohden or
Masimo)
• Line frequency
• SpHb averaging rate
• SpHb mode
• SpHb precision
• SpHb unit
• SpHb measurement (Continu-
ous or Spot Check)
F.8.1.1
Monitoring options • Alarm delay
• SpO2 averaging interval
• SpO2 sensitivity mode
•FastSat
F.8.1.3
If using two SpO
2
sensors
Define a master SpO
2
sensor or
Mixed mode
F.8.1.3
Enable specific
alarms
Enable or disable alarms for any of
your purchased measurement
parameters
F.8.1.5