Hamilton G5 - Setting up Individual Panels

7-8 624074/07
7 Monitoring
2. Select a Trend timing value of 1 h, 3 h, 12 h, 24 h, or
96 h to be applied to any trends in your layout.
3. As a
Graphics layout , select Layout 1, Layout 2,
Layout 3 . The types of graphic available for the three lay-
outs are shown below. The window closes automatically.
4. Continue setting up each individual panel (Figure 7-6).
7.3.2 Setting up individual panels
To set up the panel (in this example, change the type of wave-
form, loop, trend, or Intelligent Panel), touch the panel area of
the screen to select it. A pop-up window opens. (Figure 7-6
shows the waveform setup window). Select a parameter. If you
selected a loop or trend, additional pop-up windows will open.
Waveform Waveform Waveform,
Loop, Trend
or
Intelligent
panel
1
Waveform,
Loop, Trend
or
Intelligent
panel
1
Waveform Waveform
Waveform Waveform,
Loop, Trend
or
Intelligent
panel
1
Waveform,
Loop, Trend
or
Intelligent
panel
1
Waveform,
Loop, Trend
or
Intelligent
panel
1
Waveform,
Loop, Trend
or
Intelligent
panel
1
Waveform
Layout 1 Layout 2 Layout 3
1. Intelligent panel can be ASV graphics window, ASV monitored data window, Dynamic
lung, Vent Status, or Ventilation/Oxygenation Horizon, Map or Guide window.