Hamilton G5 - About the Masimo Spo Raw Parameter Measurements; Spo 2 Pulse Oximeter Data Display; Monitoring Window, Spo2 Raw; About the Masimo Spo 2 Raw Parameter Measurements

624074/07 F-19
F.3.1 About the Masimo SpO
2
Raw parameter
measurements
The raw data is primarily used when two sensors are in use, to
evaluate the signal quality of each sensor. In
Mixed mode (see
Section F.8.1.3), INTELLiVENT
®
-ASV uses the raw data and
quality index to determine which sensor to use as the master
sensor. You can also use this data to help determine which sen-
sor to use as the master, if not using
Mixed mode. The raw
SpO
2
data is displayed in the Monitoring -> SpO2raw tab.
Figure F-2. Monitoring window, SpO2raw
F. 4 S pO
2
pulse oximeter data display
Pulse oximeter data is fully integrated with the ventilator moni-
toring system. The specific values displayed depend on the
options available on the system. Sensor data can be presented
in the main screen as MMP or SMP (Figure 7-1), as well as in
the Monitoring window. Trend graphs are also supported for
each parameter.
For details on selecting MMP parameters, see Appendix J,
Configuration.