3-14 624074/07
3 Hardware options
3.2 SpO
2
monitoring options
The SpO
2
probe is connected to an adapter to measure
patient’s SpO
2
and pulse rate and send measured data (SpO
2
real time value, plethysmograph, pulse rate and status) to the
device.
SpO
2
measurement begins after the sensor is configured, the
SpO
2
adapter and the sensor are connected to the ventilator,
the sensor is attached to the patient, and the SpO
2
sensor is
activated.
The HAMILTON-G5 supports SpO
2
monitors from two manu-
facturers: Masimo and Nihon-Kohden.
For detailed information about the options, configuration,
installation, monitored parameters, alarms, and so on, see
Appendix F, Pulse oximetry.
Table 3-1. Airway adapter kit
Airway adapter kit
Adult/Pediatric
Weight: 4.5 grams
Dead space – adds approximately 7 ml of dead space
Intended for use when monitoring patients with
ET Tube sizes > 4.0 mm.
Airway adapter kit/
w Dehumidification
tubing
Adult/Pediatric
Weight: 4.5 grams
Dead space – adds approximately 7 ml of dead space
Intended for use when monitoring patients with
ET Tube sizes > 4.0 mm.
Airway adapter kit
Pediatric/Infant
Weight: 5.8 grams
Dead space – adds approximately 1 ml of dead space
Intended for use when monitoring patients with
ET Tube sizes
≤
4.0 mm.
Airway adapter kit/
w Dehumidification
tubing
Pediatric/Infant
Weight: 5.8 grams
Dead space – adds approximately 1 ml of dead space
Intended for use when monitoring patients with
ET Tube sizes
≤
4.0 mm.
To Next Page
Loading...