624074/07 F-39
F.9.1 Connecting the Masimo oximeter
Before you begin:
• Ensure you have all the components: adapter, adapter
cable, patient cable, sensor. See Figure F-1.
• Be sure the adapter is fully assembled; for details, refer to
the Instruction Sheet provided with the adapter.
• Inspect connector pins to confirm they are straight and
none of the pins are bent.
• The SpO
2
module(s) is already installed. See Section 2.5.
Connecting the oximeter is a simple 4-step process:
1. Attach the adapter to the rail on the trolley or other rail. See
Section F. 9 .1 . 1.
2. Attach the adapter cable to the SpO
2
module on the
ventilator. See Section F. 9 .1 .2 .
3. Attach the patient cable to the SpO
2
adapter. See Section
F.9.1.3.
4. Attach the sensor to the patient cable. See Section F.9.1.4.
Figure F-11. Fully connected oximeter (Masimo)
To Next Page
Loading...