F-20 624074/07
F Pulse oximetry
F.4.1 SpO
2
parameters in the Monitoring window
The following Monitoring window tabs show SpO
2
-related
parameters. Note that next to each parameter is a quality indi-
cator. For a description of the indicators, see Section F. 4. 2 .
NOTE:
• When a parameter shows dashes or no value, it is
not used in any calculations.
• When running the SpHb sensor in Spot Check mode,
the SpHb and SpOC values are displayed on the
screen only for 1 minute after obtaining the reading
(SpHb) and making the calculation (SpOC).
Table F-4. SpO
2
parameters in the Monitoring window
Monitoring
window tabs
SpO
2
parameters
Window 2 Displays data for the SpO
2
parameters con-
figured on your system. See Figure F-3.
SpO2raw Displays the individual raw values for each
parameter as recorded by each sensor.
Primarily used by INTELLiVENT
®
-ASV with
two sensors, to determine which sensor is
master. See Figure F-2.
To Next Page
Loading...