Hamilton G5 - Configuring the Nihon-Kohden Options; Connecting the Equipment; Configuration Spo Alarms, Using the Customize Window; F Pulse Oximetry

F-38 624074/07
F Pulse oximetry
Figure F-10. Configuration SpO
2
alarms, using the
Customize window
For more information about ventilator alarms, see Section J.4.
F.8.2 Configuring the Nihon-Kohden options
To configure the Nihon-Kohden oximeter:
1. In the
Configuration - > SpO2 window, select Nihon-
Kohden
. See FIgure F-7.
2. Select
Close and Close/Save .
F.9 Connecting the equipment
SpO
2
measurement begins after the oximeter is configured,
the SpO
2
adapter and the oximeter are connected to the
HAMILTON-G5, the oximeter is attached to the patient, and
the SpO
2
sensor is activated.