624074/07 F-45
Figure F-21. Connecting sensor to the patient cable
(Nihon-Kohden)
F.9.3 Confirming measurements
Once installed, you will verify the SpO
2
value is properly mea-
sured on the device. The first SpO
2
value is displayed after
about 10 seconds. When SpO
2
is not monitored for 30 sec-
onds, no pulse is detected and the
Patient
disconnected
alarm is displayed.
Observe that the SpO
2
sensor is active, in the
System
->
Sensor on/off
window. See Section 4.3.3.
F.9.4 Disconnecting the SpO
2
sensor
To remove the sensor cable, carefully pull back on the connec-
tor sheath at the ventilator module, and disengage from the
connector.
F.10 Troubleshooting Masimo issues
Table F-12 describes how to address some potential pulse
oximeter issues. The codes described here are displayed in the
System -> Info 2 window.
To Next Page
Loading...