7-20 624074/07
7 Monitoring
Cstat
(ml/
cmH2O)
Monitoring 1
NOTE:
Actively breathing patients can create
artifact or noise, which can affect the
accuracy of these measurements. The
more active the patient, the less accu-
rate the measurements. To minimize
patient activity during these measure-
ments, you can choose increased Psup-
port by 10 cmH2O. After completion,
return this control to its former setting.
Static compliance of the respiratory system,
including lung and chest wall compliances. It is
calculated using the LSF method applied to the
entire breath. With Cstat changes of the elastic
characteristics of the patient's lungs can be
detected.
Delay Time SBT Controls Quick Wean parameter. The minimum length
of time each parameter in the
To start
list
must be in range before the countdown to start
an automated spontaneous breathing trial
(SBT) may begin.
For details, see the Quick Wean chapter in the
INTELLiVENT
®
-ASV manual.
Duration
max
SBT Controls Quick Wean parameter. The total time that an
automated spontaneous breathing trial (SBT)
can run.
For details, see the Quick Wean chapter in the
INTELLiVENT
®
-ASV manual.
Exp Flow
(l/min)
Monitoring 1 Peak expiratory flow.
Table 7-1. Monitored parameters
Parame-
ter (unit)
Monitoring
Window
Definition
To Next Page
Loading...