HBM MGCplus - Channel Selection in Measuring Mode

Functions and symbols of the AB22A
AB22A in Setup mode
114 A0534-30.0 HBM: public MGCplus
6.3.3 Channel selection in measuring mode
There are two ways to select a channel in measuring mode:
1. With the channel keys
.
2. With direct input of the channel number using the alphanumeric keypad
(recommended with multi-channel modules).
Two examples of method 2:
Example 1: Selecting the channel of a single-channel module
► Press the numeric key of the desired channel (for example 7)
► The channel input field appears in the display with the desired channel
number.
► Confirm with
.
Example 2: Selecting a multi-channel module
► Press the numeric key of the desired slot (for example 3)
► The channel input field appears in the display with the desired slot num
ber.
(If you confirm now with
, the first subchannel, in this case 3.1, is selected).
► Enter a dot and the desired subchannel number after it.
► Confirm with
.
7
3
3.2