System
Password
MGCplus A0534-30.0 HBM: public 237
10 System
10.1 Password
You can protect all the settings of your device with a password. This
password protection is turned off in the factory settings. As soon as the
password protection is activated, the password must be entered every time
Setup mode is called (and every time the device is turned on again). Only
then can the settings be edited. The password does not need to be entered
for measuring mode alone.
Access authorization is connected with the password:
S System (all settings can be changed)
S Operator (only enabled settings can be changed)
You can define a password and access authorization for a maximum of nine
users.
Important
In the factory settings, password protection cannot be turned on until a new
user has been defined with "System" access authorization.
To Next Page
Loading...
