Starting up
Devices in the desktop housing and rack frame
MGCplus A0534-30.0 HBM: public 99
5 Starting up
This section shows you the necessary operating steps to place your mea
surement chain (measuring amplifier system and transducer) in operation.
This will enable you to perform a functional test of all the components. The
steps are deliberately described in very general terms so that there is no
need to go into the details of specific transducers or amplifier modules.
However the description can easily be applied to your measurement chain.
In some cases – especially when connecting transducers – reference is
made to the following sections. We also point out some typical errors that
may occur during start-up.
After the initial start-up is performed and the amplifier module is adapted to
your transducer, you will be ready to become familiar with the remaining
functions and possibilities of the MGCplus measuring amplifier system.
S Unpack the MGCplus.
S Check the MGCplus for damage.
S Is the delivery complete?
S Compare the contents of the package with the enclosed documentation
list. Is the documentation complete?
5.1 Devices in the desktop housing and rack frame
If you have not already received your measuring amplifier system complete,
note the following information as you put together your system:
S Plug in the measurement cards from the front and the corresponding
connection boards from the back.
The assignment is important in this process.
S If you are using the wide connection board or amplifiers (8 sub-units),
plug them into slots 1, 3, 5, etc. Slots 2, 4, 6, etc. on the front and back
must be left free or fitted with blind panels.
To Next Page
Loading...
