Measuring
General principles for adjusting a measurement channel
MGCplus A0534-30.0 HBM: public 127
Loading TEDS data into the amplifier
In the default setting, the TEDS key F2 is in level 2 of the function keys.
► Press it in Measuring mode
.
► Press the TEDS key
.
The actual amplifier will then be parameterized with the transducer settings
from the TEDS chip if it supports this functionality.
For an overview of which connection board/amplifier combinations are
TEDS-capable, see section 3.6. The amplifiers must be equipped with the
current firmware, which is available from www.hbm.com/downloads
.
To Next Page
Loading...
