Safety instructions
MGCplus A0534-30.0 HBM: public 13
This device is only to be installed and used by qualified personnel strictly in
accordance with the specifications and with the safety rules and regulations
which follow. It is also essential to comply with the legal and safety require
ments for the relevant application during use. The same applies to the use
of accessories.
Qualified personnel includes people who meet at least one of the following
requirements:
- Knowledge of the safety concepts of automation technology is a re
quirement and as project personnel, you must be familiar with these
concepts.
- As automation plant operating personnel, you have been instructed
how to handle the machinery and are familiar with the operation of the
systems, components and technologies described in this documenta
tion.
- As commissioning engineers or service engineers, you have success
fully completed the training to qualify you to repair the automation sys
tems. You are also authorized to activate, ground and label circuits
and equipment in accordance with safety engineering standards.
Safety rules
Before starting up, make sure that the mains voltage and type of current
stated on the type plate match the mains voltage and type of current at the
place of operation and that the circuit used is sufficiently protected.
The mains plug must only be inserted into a grounded socket with a protec
tion switch (protection class I).
Use only the mains cable included with delivery, which is fitted with a ferrite
core.
The device must be switched off and the mains plug disconnected from the
socket before opening the device.
Never pull the mains plug out of its socket by the supply lead.
Do not operate the device if the mains lead is damaged.
If an amplifier channel is removed, the module must be sealed with a blind
panel.
Only operate built-in devices once they are installed in the housing pro
vided.
To Next Page
Loading...
