HBM MGCplus - Page 204

Additional functions
Set peak values
204 A0534-30.0 HBM: public MGCplus
Mean-value calculation
(
PV1)PV2
)
2
F
t
PV1
PV2
Mean value
Fig. 8.4 Combining peak values with mean value calculation
Integrate gross
 G/n g = Gross signal
n = number of points
Integrate net
 N/n N = Net signal
n = number of points
The mean value of the gross/net signal is calculated over a freely selectable
time interval. The values are totalized at a sampling rate of 1200Hz (for fil
ter frequencies >5 Hz: Bessel; >10 Hz: Butterworth).
The beginning/end of integration can be set by assigning an F‐key ("Start/
Stop integration function";
è see page 234) or with a remote control contact
(INT).
Memory 1 Function
Memory 1 Envelope curve
Memory 2 Function
Memory 2 Envelope curve
PV 12-combination
Maximum gross 
Off  0 ...
ms
ms
0 ...Off 
Maximum gross 
−−−
Peak-value memory Channel 1
Off
On
Maximum gross
Maximum net
Minimum gross
Minimum net
Peak-value memory
---
Difference PV1,PV2
Mean value
Integrate gross
Integrate net
AmplifierSystem OptionsDisplay