HBM MGCplus - Page 7

Table of contents
MGCplus A0534-30.0 HBM: public 7
7.3.10 Resistors 172..................................................................
7.3.10.1 Direct entry of transducer characteristics 172.............................
7.3.11 Pulse counting 174.............................................................
7.3.11.1 Direct entry of transducer characteristics 175.............................
7.4 Current-fed piezoelectric transducer 179..................................................
7.4.1 Direct entry of transducer characteristics 180......................................
7.5 Piezoresistive transducers 182...........................................................
7.5.1 Direct entry of transducer characteristics 182......................................
7.5.1.1 Calibrating the characteristic curve of the transducer 184...................
7.6 Potentiometric transducers 186..........................................................
7.6.1 Direct entry of transducer characteristics 187......................................
7.6.1.1 Calibrating the characteristic curve of the transducer 189...................
8 Additional functions 191.....................................................................
8.1 Remote control (single-channel modules only) 191.........................................
8.1.1 Turning on remote control 191...................................................
8.1.2 Assigning remote control contacts 192............................................
8.2 Limit values (single-channel modules only) 194............................................
8.2.1 Turning on limit switches 195....................................................
8.2.2 Adjusting limit values 196.......................................................
8.2.3 Selection keys in the Limit switches menu 198.....................................
8.3 Limit value combination (single-channel modules only) 199..................................
8.4 Set peak values 202....................................................................
8.4.1 Peak-value memory 202........................................................
8.4.2 Combining peak-value memories 203.............................................
8.4.3 Control of peak-value memory 205...............................................
8.4.4 "Peak value" operating mode 205................................................
8.4.5 "Instantaneous value" operating mode 206........................................
8.4.6 Envelope curve operating mode 207..............................................
8.4.7 Clear peak-value memory 208...................................................