Hioki IM3536 - Page 169

163
External Input/Output Connector and Signals
Pin I/O
*1
Signal name Function Logic
1 IN TRIG
― ―――
External trigger
(See "Input (IN) signal function details" (p. 167).)
Rising/
falling
Edge
2 - (Unused) - - -
3 - (Unused) - - -
4 IN LD1
―――
Select panel number
(See "Input (IN) signal function details" (p. 167).)
Negative Level
5 IN LD3
―――
Select panel number
(See "Input (IN) signal function details" (p. 167).)
Negative Level
6 IN LD5
―――
Select panel number
(See "Input (IN) signal function details" (p. 167).)
Negative Level
7 IN C1
――
Switches between the high-order digit and low-order digit
during BCD output.
Negative Level
8 - ISO_5V Isolated 5 V power output - -
9 - ISO_COM Isolated common signal ground - -
10 OUT ERR
―――
Outputs when a sampling error, overcurrent error, contact
error, Hihg-Z reject error, constant voltage/constant current
error, or voltage/current limit value exceeded error occurs.
Negative Level
11
*2
OUT BIN1
――― ―
Generates output when the BIN measurement result is BIN1.
Negative Level
PARA1-HI
――――― ――
Generates output when the comparator judgment result is
HI for the No. 1 parameter.
D1-0
―― ―
BCD output signal
12
*2
OUT BIN3
――― ―
Generates output when the BIN measurement result is BIN3.
Negative Level
PARA1-LO
――――― ――
Generates output when the comparator judgment result is
LO for the No. 1 parameter.
D1-2
―― ―
BCD output signal
13
*2
OUT BIN5
――― ―
Generates output when the BIN measurement result is BIN5.
Negative Level
PARA3-IN
―――――――
Generates output when the comparator judgment result is
IN for the No. 3 parameter.
D2-0
―― ―
BCD output signal
14
*2
OUT BIN7
――― ―
Generates output when the BIN measurement result is BIN7.
Negative Level
AND
―――
Outputs judgment results for two parameter measured val-
ues (the result of a logical AND operation).
Generates output when both judgment results are IN. Ad-
ditionally, generates output when either of the No. 1 or No. 3
parameters is IN and the other is undetermined.
D2-2
―― ―
BCD output signal
15 OUT BIN9
――― ―
Generates output when the BIN measurement result is BIN9.
Negative Level
D3-0
―― ―
BCD output signal
16 OUT D3-2
―― ―
BCD output signal Negative Level
17 OUT D4-0
―― ―
BCD output signal Negative Level
18 OUT D4-2
―― ―
BCD output signal- Negative Level
19 OUT OUT_OF_BINS
― ― ― ― ― ――― ―
Generates output when the BIN judgment result does not match
any BIN.
Negative Level
20 IN C2
――
Switches between the No. 1 parameter and No. 3 parameter
during BCD output.
Negative Level
21 IN CALIB
― ― ―――
DC adjustment request
(See "Input (IN) signal function details" (p. 167))
Negative Level
22 IN LD0
―――
Select panel number
(See "Input (IN) signal function details" (p. 167).)
Negative Level
9
External Control